鍥炲埌椤堕儴
 Anping Tianyue Welded Wire Mesh Co., Ltd

Home page  Favorites   ty1@dianhanwang.com

 

 
  • Home
  • About Us
  • Products
  • Our Service
  • News
  • Quality Control
  • Workshop
  • Pack & Loading
  • Contact Us
  •   Categories
      Featured Products
      Bar Grating

    Bar Grating

     

    STEEL GRATING STANDARDS:

    1.        CHINA: YB/T4001-1998

    2.        U.S.A.:ANSI/NAAMM (MBG531-88)

    3.        U.K.:BS4592-1987

    NOTES:

    1. Bearing bar pitches may be 15 to 22, 25, 30, 32.5, 34, 40, 50, 60, 80, 90mm, of which 25, 30, 34 and 40mm are recommended.

    2. Cross bar pitches maybe 24-200mm, of which 50mm, 76mm and 100mm are recommended.

    3. Steel grating is made by the world first-class equipment, which can arrange the bearing bar and cross bar in longitude and latitude order to certain distance. Cross bar is pressed into the bearing bar by high tension resistance welding ring which is controlled by computer. So we can produce high quality gratings with firm welding, smooth surface and high strength.

      

    4. Surface Process of Gratings: there are three types: hot-dipped galvanizing, Electro-Galvanized and spraying brushing and soaking. Anti-acid and alkali corrosion capacity: the range PH6 to PH12.5, a stable protective film will be formed on the zinc surface. It has good anti-corrosive property.

    5. Packing Conditions of Steel Grating: Normally packed in piling up ways with two pieces of square wood on both upper and bottom sides. There are four or six pieces of M10 long bolt penetrating the gratings and screwing together. It is suitable for loading and unloading by fork-lift and crane. Note: we can pack as per the requirement of customers.

      
    6. Ordering Information:

    Please provide the type and area of grating needed, and also the dimension and quantity. Provide us the necessary flat drawing when you need large area grating:
    A) Dimensions of total area of grating.

    B) Supporting structure (including section dimension, location of supporting beam and open direction of channel steel)

    C) Location and dimension of nosing, end plate and specified profile connection.

    D) Location and dimension of nosing, end plate and specified profile connection.

    E) Indicate the type and quantity of installation fastener, at least four lots of fasteners needed for each panel in principle. Indicate the type, pieces and dimension of stair tread, surface treatment and whether to change angle for side. Area of grating is accounted by gross area, which is accounted by maximum outside dimension, including cutout and gap.

    F) Only all above items are clarified, you will get the exact offer.

       

      

      

     

    Copyright 2011: Anping TianYue Welded Wire Mesh Co.,Ltd.      E-mail:ty1@dianhanwang.com